Used Parts for Forklifts - In the long run, lift truck parts will wear and need to be replaced. Acquiring brand new components could become a pricey endeavor so one more idea is to obtain used lift truck components. This can save much money in the long run. It is a good idea to buy used forklift components that have been remanufactured. These components would ensure that you are getting parts that will work for a long time and be productive.
Worn or broken parts that are remanufactured are a very cost effective answer as opposed to rebuilding. With rebuilding components, only the components which are worn out or broken get replaced, which means that other wearable components can break down soon after acquisition.
Remanufacturing however offers the best guarantee for second-hand components. Remanufactured components are taken apart and cleaned and then all wearable pieces are replaced. All wearable parts are replaced regardless of age or wear which is one more rationale why reproduced parts generally perform so much better. Whatever component within the part is brand new and this offers much longer life to the second-hand part. Based on the forklift components which are being redone, the cleaning process and the whole remanufacturing process will vary.
After complete disassembly, the engines are oven cleaned. Different components of the engine like for instance pistons, spark plugs, rings, valve springs, filters, and valves can be replaced during the remanufacture process. The engines are hot tested after reassembly to ensure that there are no oil pressure problems, no leaks, noises or any vacuum.
Transmissions are another item which is oven cleaned after being disassembled. The transmission is then washed. A complete examination is done so as to check for any cracks. Bushings, seals and bearings are all replaced. Usually, the replacement components utilized on transmission components meet OEM specifications.
A few forklift components like for example the water pump, torque converters, the alternator, the starter and steer axles could be quite serviceable after worn parts are replaced. The electronic control in the electric forklift is maintained by the control card. This particular card can also be remanufactured with replacing all aged and worn out components. Not like various forklift components the control card could only have the worn and aged components replaced.
Components that are reproduced have to be meticulously checked upon reassembly to guarantee they are in good condition previous to being sold. When acquiring these components, it is a good idea to be certain that they have undergone all of the proper testing and inspections. On certain bigger parts such as transmissions, steer axles and engines, OEM specification replacement parts must be used.
The lift truck dealer could guarantee that the components they have remanufactured meet the OEM specifications. This would also guarantee the parts meet industry standards. Lots of details go into remanufacturing second-hand components. This attention to detail offers more serviceability out of reproduced components opposed to the parts that were just rebuilt.
Click to Download the pdf